Canoga-perkins 9175 Configuration Guide Manual do Utilizador descarregar pdf (Página 49)

CanogaOS Configuration Guide

9-3

DUT(config) # interface eth-0-9 Enter the Interface mode.

DUT(config-if) # static-channel-group 11 Add this interface to a static channel group 11 and

enable link aggregation so that it can be selected for

aggregation by the local system.

DUT(config-vlan) # exit Exit the interface mode and enter the Configure mode.

Configure interface eth-0-13

DUT(config) # interface eth-0-13 Enter the Interface mode.

DUT(config-if)#switchport mode trunk Set the switching characteristics of this interface to

trunk mode.

DUT(config-if)#switchport trunk allowed vlan add 15 Enable VLAN 15 on this port.

DUT(config-vlan) # exit Exit the interface mode and enter the Configure mode.

Configure and enable ERPS domain

DUT(config) # erps 11 Create erps domain with id 11.

DUT(config) # erps 11 primary control vlan 15 Set vlan 15 as the primary control vlan of erps domain

11.

DUT(config) # erps 11 ring 1 level primary Create an erps primary ring 1 for domain 11.

DUT(config) # erps 11 ring 1 mode master Set node as master of ring 1 for domain 11.

DUT(config) # erps 11 ring 1 primary interface agg11 Set primary interface of ring 1 for domain 11.

DUT(config)# erps 11 ring 1 secondary interface

eth-0-13

Set secondary interface of ring 1 for domain 11.

DUT(config) # erps 11 ring 1 enable Enable ring 1 for domain 11.

DUT(config) # erps 11 enable Enable domain 11.

Switch 2

Create VLAN for transferring ERPS control packets

DUT# configure terminal Enter the configure mode.

DUT(config) # vlan database Enter VLAN database mode.

DUT(config-vlan) # vlan 15 Creat vlan 15.

DUT(config-vlan) # exit Exit the vlan mode and enter the Configure mode.

Configure interface agg11