Canoga-perkins 9175 Configuration Guide Manual do Utilizador descarregar pdf (Página 268)

CanogaOS Configuration Guide

45-1

45 Configuring User Management

User management increases the security of the system by keeping the unauthorized

users from guessing the password. The user is limited to a specific number of attempts

to successfully log in to the switch.

There are three load modes in the switch. In “no login” mode, anyone can load the switch

without authentication. In “login” mode, there is only one default user. In “login local”

mode, if you want to load the switch you need to have a user account.

Local user authentication uses local user accounts and passwords that you create to

validate the login attempts of local users. Each switch has a maximum of 32 local user

accounts. Before you can enable local user authentication, you must define at least one

local user account.

You can set up local user accounts by creating a unique username and password

combination for each local user. Each username must be fewer than 32 characters.

You can configure each local user account with a privilege level; the valid privilege levels

are 0 or 15. Once a local user is logged in, only the commands those are available for

that privilege level can be displayed.

45.1 Configuring the user management in login local mode

45.1.1 Enabling password checking

In order to authenticate the user access by a user name and password, the login mode

must be set to login local first as following steps:

DUT# configure terminal Enter global configuration mode.

DUT(config)# line vty 0 7 Enter line configuration mode, use line console 0 if you

want to set console port access.

DUT(config-line)# login local Enable local login authentication on the switch.

DUT(config)# exit Exit the Configure mode

This is a sample output from the command displaying how to enable local login

authentication on the switch:

DUT(config)# line console 0

DUT(config-line)# login local

45.1.2 Setting high level of cipher detect

If you have set high level of cipher detect, the password must contain digital, normal char

and special char. And if you have set normal level of cipher detect, the password must

contain digital and normal char. The password can be any char, if you don’t choose

cipher detect.

To set high level of cipher detect, follow these steps:

DUT# configure terminal Enter global configuration mode.

DUT(config)# cipher detect strong Set high level of cipher detect on the switch

DUT(config)# exit Exit the Configure mode

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 279 280

Sem comentários

Canoga-perkins 9175 Configuration Guide Manual do Utilizador Página 268