Canoga-perkins 9145EMP Network Interface Device Hardware Manual do Utilizador descarregar pdf (Página 39)

Installation 9145EMP Network Interface Device Hardware User’s Manual

Connecting the Electrical Power

3.5.4 Connecting the Fiber Optic and UTP Ethernet Cables

3.5.4.1 Optical Fiber Cable Installation

NOTE: To avoid damaging the fiber end-surface or connector, use extreme care

when installing or removing cables.

Connect the Optical Fiber cables to the SFP modules as follows:

1. Plug in the optical cables with proper Tx to Rx or Rx to Tx orientation.

2. Ensure connector locks in place.

3. Label each cable with the signal direction (TX or RX).

3.5.4.2 UTP Cable Installation

Connect the UTP cables to the RJ45 connectors as follows:

1. Plug the UTP Cable into the RJ45 connector.

2. Be sure the locking tab is properly seated.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 49 50

Sem comentários

Canoga-perkins 9145EMP Network Interface Device Hardware Manual do Utilizador Página 39