Canoga-perkins 9145E Ethernet Network Interface Device Hardware Manual do Utilizador descarregar pdf (Página 21)

Functional Description 9145E Ethernet Network Interface Device User’s Manual

Port Default Settings

2.5 Port Default Settings

Table 2-2 represents the default settings for each of the ports. The term active connector refers to

the connector, either UTP or SFP, that is currently enabled. For example, if a particular 9145E

model has a User Port with both UTP and SFP connectors present, by default the UTP is the

Active Connector (it can currently transmit and receive data), while the SFP is the Inactive Con-

nector (i.e., it currently cannot transmit or receive data).

Table 2-2. Default Port Settings

NOTE:Cells in yellow denote which of the connectors are active by default

2.6 Power Connectors

The 9145E will accommodate both single and redundant AC and DC powering options, along

with mixed AC and DC power.

2.6.1 Power Requirements

100 VAC to 240 VAC (auto-ranging), 50 to 60 Hz, 0.5 amps

36 VDC to 72 VDC, 1.0 amps

2.6.2 Single AC Power Base Unit

The Single AC powered 9145E base unit (see Figure 2-3) has an IEC 320 power connector on

the rear panel. An appropriate AC power cord is supplied with the unit.

Figure 2-4. Single AC Power

UTP

SFP w/ 100

Mbps Optics

SFP w/ 1000 Mbps

Optics

SFP w/ Multispeed

Optics (100 to 1000)

User Port Auto 100 FD 1000 FD 1000 FD

Network Port Auto

100 FD 1000 FD 1000 FD

Multipurpose Port Auto

100 FD 1000 FD 1000 FD

Mgmt UTP port

Auto N/A N/A N/A

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 53 54

Sem comentários

Canoga-perkins 9145E Ethernet Network Interface Device Hardware Manual do Utilizador Página 21